LEXMARK T645 DRIVER

Image 9a Image 9b 10 Send the old fuser kit back to Lexmark for recycling purposes. If the printer still will not pull any paper, your feed rollers may be worn. Image 2 3 Press the two side latches to open the fuser access door. Image 3 4 Install the separator roller assembly by inserting first the right-hand side if you are facing front of the media tray , and then insert the left side. If so, please open the front door and remove the toner cartridge.

Uploader: Gutaxe
Date Added: 22 April 2014
File Size: 44.1 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 25545
Price: Free* [*Free Regsitration Required]

Image 5a Image 5b. However, you should be able to continue to use the printer temporarily. You should hear a clicking sound indicating that the roller has been locked in place. Image 1 2 Press the button to release the separator roller from the lexmarrk tray.

Look into leexmark printer where the tray goes. For service in other countries, please refer to the contact numbers listed on the Drivers CD. Image 7a Image elxmark 8 Close the Control panel cover and front door. Unpack the new transfer roller kit from the package but do not remove the protective plastic covering the foam surface.

Image 4a Image 4b 5 Insert the transfer roller starting on the left side and then on the right. Solution When you first receive this error, do the following: Contacting Lexmark Technical Support: Clean off the rollers with a dry cloth and try printing again.

  HP 882C XP DRIVER DOWNLOAD

If the printer still will not pull any paper, your feed rollers may be worn. Take out paper tray 1. When installing the new transfer roller, avoid all contact with the foam surface, or print quality issues might result.

Remove any and all jammed sheets of paper you find. If you need help locating these, click here. Insert the transfer roller starting on the left side and then on the right.

Image 6a Image 6b. Image 1a Image 1b.

Make Your Selection

This document outlines the proper replacement procedure for each of the parts. Please enter the email address you would like to send a copy of this page to.

Look into the printer where the paper tray goes. Also make sure the printer is powered off and unplug any and all cords, especially the power cord, going into the printer.

Buy Products Online from China Wholesalers at

You should see a slot or guide where the paper will go once it is fed out of the tray. If the printer jams again with a Paper Jam error message, look to see if it has tried to feed a sheet of paper out of the tray. Image 3 4 Install the separator roller assembly by inserting first the right-hand side if you are facing front of the media trayand then insert the left side.

  CANON TS9120 DRIVER DOWNLOAD

Solution A RIP Software error indicates that the printer has encountered an error while processing a print job. Click the link to watch the tutorial video on How to replace the Fuser kit. Image 9a Image 9b 10 Send the old fuser kit back to Lexmark for recycling purposes. Image 5 6 Insert the new fuser kit and tighten the two fuser thumb screws.

Note For jam removal instructions specific to your printer, please refer to the User’s Guide that came with the printer. Please enter the email address you would like to send a copy of this page to.

If you cannot reach it or it cannot be removed, the assistance of a service technician will probably be needed. Image 6a Image 6b 7 Close the fuser access door.

Also open the rear door of the printer and the duplex option if a duplex unit is installed. Gently move the transfer roller rightward to disengage it from the left transfer roller arm.